Unfolding The Handle - Toro Flex-Force Power System 39901 Operator's Manual

2

Unfolding the Handle

No Parts Required
Procedure
1. Remove the machine from the box.
2. Unfold the upper handle and allow the upper
handle knobs to snap into place (A of
3. Tighten the handle knobs (B of
4. Remove the lower handle knobs from both sides
of the machine (Figure
Note:
The lower knobs are installed to a weld
nut in the side of the machine.
Right side shown
1. Lower handle knob
Figure
Figure 3).
Figure 3
4).
Figure 4
5. Move the lower handle into place and install the
lower handle knobs as shown in
Note:
You may use a wrench on the hex on the
outside of the knob to tighten the knob.
Important:
handlebar touches the side plate with no gap.
3).
1. Align the lower handle with
the weld nuts.
g282574
g303594
8
Figure
Tighten the knobs until the
Figure 5
2. Install the lower handle
knobs.
5.
g303595