Adjusting The Discharge Chute And Chute Deflector - Toro Flex-Force Power System 39901 Operator's Manual

Figure 14
1. LED indicator light
2. Charger venting areas
5. To remove the battery pack, slide the battery
backward out of the charger.
6. Refer to the following table to interpret the LED
indicator light on the battery charger.
Indicator light
Off
Green blinking
Green
Red
Red blinking
*Refer to Troubleshooting (page 16)
information.
g268087
Indicates
No battery pack inserted
Battery pack is charging
Battery pack is charged
Battery pack and/or battery
charger is over or under the
appropriate temperature range
Battery pack charging fault*
for more
Adjusting the Discharge
Chute and Chute Deflector
To adjust the discharge chute, move the handle on
the chute-control rod in the direction that you wish to
direct the snow stream.
To adjust the chute deflector (and therefore the height
of the snow stream), squeeze the trigger and raise or
lower the chute deflector
1. Chute deflector trigger
WARNING
A gap between the discharge chute and the
chute deflector may allow the machine to
throw snow and objects in the direction of the
operator. Thrown objects could cause serious
personal injury.
• Do not force the chute deflector too far
forward so that a gap appears between the
discharge chute and chute deflector.
• Do not adjust the chute deflector with the
power control bar engaged. Release the
power control bar before adjusting the
chute deflector.
13
(Figure 15).
Figure 15
g318452