Charging The Battery Pack - Toro Flex-Force Power System 39901 Operator's Manual

1. Turn ECO mode on
Shutting Off the Machine
1. Release the bail (A of
2. Remove the electric-start button from the electric
starter (B of Figure
3. Remove the battery pack; refer to
Battery Pack from the Machine (page
Note:
Whenever you are not using the
appliance, remove the battery pack.
Figure 12
Removing the Battery Pack
from the Machine
1. Lift up the battery-compartment lid.
2. Press the battery pack-latch to release the
battery pack and remove the battery pack.
3. Close the battery-compartment lid.
Figure 11
2. Turn ECO mode off
Figure 12).
12).
Removing the
12).

Charging the Battery Pack

Important:
The battery pack is not fully charged
when you purchase it. Before using the machine
for the first time, place the battery pack in the
charger and charge it until the LED display
indicates the battery pack is fully charged. Read
all safety precautions.
Important:
Charge the battery pack only in
temperatures that are within the appropriate
range; refer to
Note:
At any time, press the battery-charge-indicator
button on the battery pack to display the current
charge (LED indicators).
g318457
1. Make sure that the vents on the battery are clear
of any dust and debris.
2. Line up the cavity in the battery pack
with the tongue on the charger.
1. Battery pack cavity
2. Battery pack venting areas 5. LED indicators (current
g247446
3. Battery pack terminals
3. Make sure that the vents on the battery charger
are clear of any dust and debris.
4. Slide the battery pack into the charger until it is
fully seated
12
Specifications (page
Figure 13
4. Handle
charge)
6. Battery-charge-indicator
button
(Figure 14).
10).
(Figure 13)
g282651