Removing And Installing The Divider Plate - Toro CM Series Operator's Manual

Removing and Installing the
Divider Plate
You need to remove the divider plate to provide access before
performing some maintenance procedures.
Removing the Divider Plate
1. Unlatch and open the cowl; refer to
(page 22).
2. Use a wrench to remove the 4 bolts that secure the
divider plate to the front cowl.
Note: Retain the bolts and washers for installing the
divider plate.
Figure 39
3. To remove the divider plate, lift it upward and tilt it
back so that it clears various engine components.
Installing the Divider Plate
1. Guide the divider plate into position against the front
Opening the Cowl
2. Align the bolt holes in the divider plate and the front
3. Install each of the 4 bolts and hand-tighten them to
4. Tighten the bolts with a wrench until they are secure.
G021094
29
cowl.
Note: Start with the divider plate tilted slightly back,
then tilt it forward while lowering it into position.
Figure 40
cowl.
prevent cross-threading.
G021 102