Toro CM Series Operator's Manual page 17

1 3
4 2
Raising the Stabilizer Legs
End-Dump Models Only
End-dump models have a front stabilizer leg and 2 rear
stabilizer legs.
Raise the stabilizer legs before towing the machine.
1. Adjust the machine so that there is no weight resting
on the rear stabilizer legs.
2. Pull the clevis pin out from 1 of the rear stabilizer legs
and the bracket (Figure
3. Slide the stabilizer leg up in the bracket and align the
pin hole of the bracket with the lower hole in the
stabilizer leg (Figure
4. Push the clevis pin through the hole in the bracket and
the stabilizer leg (Figure
5. Repeat steps 1 through
leg.
6. Lift upward on the tongue so that there is no weight
resting on the front stabilizer leg.
Figure 19
20).
Figure 20
20).
20).
4 for the other rear stabilizer
7. Pull the clevis pin out from the front stabilizer leg and
the tongue
G021 107
1. Remove the clevis pin.
2. Rotate the stabilizer leg
up.
8. Rotate the front stabilizer leg up into the tongue
(Figure
9. Push the clevis pin through the rearward hole in the
tongue and the front stabilizer leg
G019917
17
(Figure 21).
2
Figure 21
3. Install the clevis pin.
21).
3
1
G019915
(Figure 21).