Advertisement
3.6 CLEAN & LUBRICATING MACHINE
All protective coating must be removed before using machine, do not attempt to
move any ways if the coating still exists.
Be cautious while selecting a suitable cleaning agent, paraffi n applied with a clean
brush to take off protective coating, the protective coating be removed with clean
rags.
Note:1. Do not use gasoline or any other fl ammable solution clean machine.
2. Clean and lubricate all the exposed ways of table and saddle, drive
the table and saddle to one end of travel, clean and lubricate ways
thoroughly then drive table and saddle to the other end, and clean
lubricate ways thoroughly as well, be sure to use a suitable lubricant
such as Sunoco Way lube#11180 or Mobil Vactra Oil#2.
3.7 LEVELLING MACHINE
It is necessary to level the machine before starting to operate the machine.
Please prepare the following tools to adjust machine leveling:
1.
Accurate spirit leveling gauge (spec. 0.02mm/1000mm or 0.001in/4 ft.).
2.
Two adjustable wrench
Clean the table surface thoroughly, set one of the spirit leveling gauge
on the longitudinal direction and the other on the cross direction of the
slide.
If there is only one leveling gauge available, then use it on both directions
alternately.
Adjust the six leveling screws bolts which located the botton of the
machine base(as show in Figure 3) until the machine is leveled within
0.02mm/1000mm (0.001"/4ft) in both directions.
Lock the nut "A" on the leveling screws, and re-check the level to see
whether the level of machine is still correct.
Figure 3
-29-
Advertisement
