Advertisement
Figure 15
1. Black wire
2. Ground terminal block
4. Connect the red wire to the load side of the
auxiliary solenoid.
Note: The load side can be determined
by testing both solenoid posts when the
ignition is turned off. The hot side will read
approximately 12V , while the load side has no
voltage. The load side can be confirmed by
turning the ignition to the run or On position
and testing the load side again. The load side
will read approximately 12V with the ignition
on. Turn the ignition to Off and remove
the key before continuing with any of the
installation or maintenance.
5. Lower the seat.
3. Red wire
4. Auxiliary solenoid
Step
5
Installing the Controls on a
Multi Pro 5600 or 5700-D
Turf Sprayer
No Parts Required
Procedure
Installing the Switches
Note: The following procedure assumes boom
lift switches are installed on the machine. For
machines without boom lift switches or if you
have not already installed the switches from the
Electric Boom Lift Kit, install those switches now
as described in the instructions with that kit. Do
not install the wire harness than comes with the
Electric Boom Lift Kit.
1. Remove the spray control panel to expose the
bottom side (Figure 16).
Figure 16
1. Spray control panel
2. Latch
3. Switch
2. Remove the plug in the sonic boom slot from
the spray control panel on the vehicle and
install the rocker switch provided in its place
(Figure 16).
Note: Ensure that the orientation of the
switch matches what is shown in Figure 16,
with the notch pointing toward the rear of the
vehicle.
9
4. Plug
5. Notch
Advertisement
