Advertisement
Step
6
Installing the Controls on a
Workman Spray System
Parts needed for this step:
1
Indicator light
1
Grommet
Procedure
Install the Switches
1. Remove the four screws in the front of the
control panel cover to access the internal
components. Retain all fasteners.
2. In the area just above the sonic boom switch
plug, drill a 0.375 inch diameter hole to
accommodate the indicator light (Figure 18).
Figure 18
1. Spray control panel
2. Screws
3. Install the indicator light through the back of
the hole. Secure it to the front panel with the
fasteners included (Figure 19).
4. Remove the sonic boom switch plug from the
front panel and install the sonic boom rocker
switch (Figure 19).
3. Drilled hole, 0.375 inch
diameter hole
4. Sonic boom plug
Figure 19
1. Spray control panel
2. Sonic boom plug
3. Existing boom lift switches 7. Sonic boom connector,
4. Existing boom lift
connectors
5. Locate and disconnect the plugs for the boom
lift switches (Figure 19).
Important: Do not cut or remove unused
connectors. Store the unused connectors in
the control box for future use in the event
the sonic boom kit is removed.
6. Change the orientation of the boom lift
switches:
A. Locate the boom lift switches in the control
panel. Remove both switches from the
panel.
B. Using a flat head screw driver or similar
tool, gently pry the rocker switch covers
from the switch bodies (Figure 20).
11
5. Indicator light, install
6. Sonic boom switch
from sonic boom wire
harness
8. Boom lift connectors, from
sonic boom wire harness
Advertisement
