Advertisement
Figure 3
1. Extension boom
2. Wire clips
3. Boom supply hose
8. Route the sensor wire below the slide block
to the boom supply hose and on to the center
boom assembly. Secure the wire harness to the
boom hose with the cable ties (Figure 3).
Important: Ensure that the wire is
routed below the slide block to avoid being
pinched when the booms are placed in the
transport cradle.
9. Use 5 cable ties to secure the harness to the
boom support.
Important: Ensure that you leave
enough slack in the wire near the joint of
the extension boom so that you can raise
and lower the boom without pulling on the
wire.
10. Repeat steps 2 through 9 for the left boom
extension and left ultrasonic sensor.
Use the following procedure for boom systems
259999999 and below.
1. Park the sprayer on a flat surface, lower the
booms, set the parking brake, stop the engine,
and remove the key.
2. Lightly secure the right ultrasonic sensor to
the right boom pipe halfway between the last
nozzle and the vertical support (Figure 4),
using 2 U-bolts, 4 washers (5/16 inch), and 4
locknuts (1/4 inch).
4. Wire from sensor
5. Slide block
6. Cable tie
Figure 4
1. Sensor
2. U-bolts
3. Install the rubber sensor cover to the threaded
portion of the ultrasonic sensor.
4. Install the protection tube around the
ultrasonic sensor with the angled side facing
inward, toward the vehicle. Lightly secure the
protection tube to the boom (Figure 4), using 2
U-bolts, 4 washers (5/16 inch), and 4 locknuts
(1/4 inch). Do not fully tighten at this time to
allow for later adjustment.
5. Rotate the sensor up so that it is approximately
10 degrees off parallel with the ground, then
tighten the locknuts on the U-bolts to secure
the sensor (Figure 5).
Figure 5
6. Route the sensor wire along the top of the
boom support to the center of the center
boom pipe.
4
3. Locknuts and washers
4. Protection bar
Advertisement
