Advertisement
Note: The following procedure assumes boom
lift switches are installed on the machine. For
machines without boom lift switches or if you
have not already installed the switches from the
Electric Boom Lift Kit, install those switches now
as described in the instructions with that kit. Do
not install the wire harness than comes with the
Electric Boom Lift Kit.
1. Remove the spray control panel to expose the
bottom side (Figure 13 for the 1250 and Figure
14 for the 1200).
Figure 13
1. Plug
2. Switch
Figure 14
1. Sonic boom switch location 2. Spray control panel
2. Remove the plug in the sonic boom slot from
the spray control panel on the vehicle and
install the rocker switch provided in its place
(Figure 13 for the 1250 and Figure 14 for the
1200).
3. Notch (at back)
4. Spray control panel
Note: Ensure that the orientation of the
switch matches what is shown in Figure 13,
with the notch pointing toward the rear of the
vehicle.
Wiring the Switches
1. Route the branch of the sonic boom wire
harness with the three large connectors into
the control panel area.
2. If boom lift switches are installed remove
any existing connectors plugged into the lift
switches.
3. Connect the connector with green and white,
green and black, and black wires to the bottom
of the right boom lift switch.
4. Connect the connector with blue and white,
blue and black, and black wires to the bottom
of the left boom lift switch.
5. Connect the connector with purple, yellow,
and black wires to the bottom of the sonic
boom switch.
6. Route the free end of the wiring harness down
through the floor and rearward, following the
spray system wire harness to the center boom
assembly at the back of the vehicle. Use cable
ties to secure the wiring harness to the other
wiring harnesses away from the engine and
moving parts.
7. Install the spray control panel and secure it
with the fasteners removed previously.
Connecting the Wiring to the Fuse Block
1. Route the branch of the sonic boom wiring
harness with the small spade connector and a
ring or fork terminal into the seat box and to
the fuse area.
2. Lift the seat to access the fuse area. Locate the
auxiliary solenoid and ground terminal block.
3. Connect the ring labeled ground on the black
wire to the ground terminal block (Figure 15).
8
Advertisement
