Table of Contents
Advertisement
T
O REMOVE THE HARD DISK DRIVE
1 If you are removing the hard disk drive in order to install a new drive, give the network
2 Shut down and open the ColorPASS (see pages
3 Remove the power supply cable from the hard disk drive.
4 Remove the hard disk drive data cable from the hard disk drive.
5 Remove the screw securing the hard disk drive bracket to the bracket shelf.
6 Slide the hard disk drive bracket off the shelf and lift it out of the chassis (see
Tension points
Copier interface and
N
:
OTE
internal cables are not shown.
S
P
ERVICE
ROCEDURES
administrator the opportunity to print the Job Log and save any custom simulations.
If possible, print the Configuration page and Font List.
To access the hard disk drive, you must remove the left panel.
Unlock the hard disk drive bracket by moving the latch toward the back panel, and then
sliding the bracket off the bracket shelf.
Avoid striking the DIMMs as you remove the hard disk drive bracket.
You will encounter slight resistance as you slide the bracket off the shelf. The resistance
N
:
OTE
is caused by two tension points on the bottom of the bracket. The resistance helps control the
bracket's movement during removal and installation.
Removing/replacing the hard disk drive bracket
F
32:
IGURE
48
and 51).
92
Figure
32).
Latch
Hard disk
drive bracket
Shelf
Screw
Advertisement
Table of Contents
