Table of Contents
Advertisement
S
P
ERVICE
ROCEDURES
T
O TRANSFER OPTIONS TO THE NEW MOTHERBOARD
This procedure assumes that the ColorPASS is fully assembled, verified in Service
N
:
OTE
Mode (see
page
70), and powered off.
1 Make sure that the one-time use dongle is firmly attached to a USB port on the ColorPASS
and that no other dongles (such as for SeeQuence Impose or Compose) or USB storage
devices (except for the keyboard and mouse, if present) are attached to the ColorPASS.
The options transfer process may fail if other dongles and/or USB storage devices are
connected to the ColorPASS during the process.
2 Power on the ColorPASS.
3 Immediately insert the Fiery Options Utility DVD into the DVD drive.
The Fiery Options Utility DVD must be in the DVD drive in time for the ColorPASS
N
:
OTE
to boot from it. If the ColorPASS does not boot from the Fiery Options Utility DVD, allow
the ColorPASS to start up, eject the DVD, turn off the ColorPASS, and then repeat steps 2
and 3.
If an error message displays, see
N
:
OTE
4 To continue, choose the Control Panel or monitor (if present) as the interface to use
throughout the option transfer process.
The first screen that displays when you start the Fiery Options Utility allows you to choose
the interface that you will use throughout the procedure. Choose an interface by selecting OK
on the Control Panel or monitor. The interface not chosen is then disabled during the option
transfer process.
Control Panel
Press OK to
continue
Options Utility
page
75.
Monitor
OK
Fiery Options Utility
To continue running the Fiery
Options Utility using the monitor,
keyboard and mouse, press Enter
or click OK. To continue running
the Fiery Options Utility using the
Fiery Control Panel instead, press
OK on the Fiery Control Panel.
OK
72
Advertisement
Table of Contents
