Huawei eSpace 6805 Administrator's Manual page 119

eSpace 6805 IP Phone
Administrator Guide
Figure 6-39 Complete the DHCP server
After the setting is complete, if some IP phones are set to obtain IP addresses through DHCP,
the DHCP server allocates the IP addresses in the IP address pool to the IP phones one by one.
If the lease of IP addresses is not renewed, the DHCP server withdraws the IP addresses for
use of other devices.
----End
6.6.2 Setting Up the DHCP Server on Router AR-28
The configuration scripts and remarks for logging in to router AR-28 and enabling the DHCP
server function are as follows:
<Quidway>system-view
[Quidway]dhcp enable
router.
[Quidway]dhcp server detect
[Quidway]interface Ethernet 0/1
[Quidway-Ethernet0/1]ip address 192.168.2.1 255.255.255.0
address of network port 0/1. The router also uses the IP address as the gateway
address and allocates the IP address to the DHCP client.
Issue 01 (2014-01-06)
You must make sure that the network cable is inserted into network port 1 of board 0 on router AR-28.
In the rear panel of the router, you can view the board slots and enable DHCP function on network port
1.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
//Enter the configuration mode.
//Enable the DHCP server function of the
//Verify the DHCP server function.
//Connect to network port 1 on board 0.
6 Appendix
//Set the IP
117