Toro TX 427 Operator's Manual page 33

Figure 43
1. Battery
2. Bar
3. Positive cable
5. Disconnect the negative (black) ground cable
from the battery post
fasteners.
6. Slide the rubber cover off the positive (red)
cable.
7. Disconnect the positive (red) cable from the
battery post (Figure
8. Gently push the hydraulic hoses aside and lift
the battery out of the chassis.
Charging the Battery
Important:
Always keep the battery fully charged
(1.265 specific gravity). This is especially
important to prevent battery damage when the
temperature is below 0°C (32°F).
1. Remove the battery from the machine; refer to
Removing the Battery (page
2. Charge the battery for 10 to 15 minutes at 25 to
30 A or 30 minutes at 4 to 6 A
not overcharge the battery.
4. Rubber cover
5. Negative cable
(Figure 43). Retain the
43). Retain the fasteners.
32).
(Figure 44). Do
1. Positive battery post
2. Negative battery post
g005293
3. When the battery is fully charged, unplug
the charger from the electrical outlet, then
disconnect the charger leads from the battery
posts (Figure
33
Figure 44
3. Red (+) charger lead
4. Black (-) charger lead
44).
g003792