Huawei PowerCube 500 V200R001C10 Quick Manual page 15

Hide thumbs Also See for PowerCube 500 V200R001C10:
Table of Contents

Advertisement

(The information displayed in the following figure is for reference only.)
Configuring Serial Port Transparent Transmission
In the system view, run the following commands:
1. Run the user-interface tty 2 command to access the TTY user interface view. For the RS422/485 serial port, the TTY value is 2.
2. Run the mode raw command to set the serial port service mode to RAW and access the RAW service view, or access the existing RAW
service view.
By default, the serial port service mode is NONE.
3. Run the undo raw-transport enable command to disable the RAW service function.
By default, the RAW service function is disabled.
The device working mode in the serial port transparent transmission service and the basic properties of the service
should be configured when the RAW service is disabled.
4. Run the raw-transport tcp server server-port 5000 command to appoint the device as the server and to transparently transmit serial port
data over TCP. The appointed listening port of the server is 5000.
5. Run the raw-transport enable command to enable the RAW service function.
NOTE
By default, the RAW service function is disabled.
The device working mode and the basic properties of the serial port transparent transmission service configured in the
RAW service view take effect only after the RAW service is enabled.
6. Run the quit command.
(The information displayed in the following figure is for reference only.)
NOTE
Check the configuration result and verify that the server can receive data collected by the function module.
Run the display transport info command to check the serial port service configuration.
Run the display transport mode command to check the serial port service mode.
Run the display transport session command to check the serial port session information.
Run the display transport stat command to check the serial port status information.
Run the display ip interface brief [ interface-type
[ interface-number ] ] command to view the brief
information about the IP address for the interface.
15

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ar550cx-300h1Ar550cx-300g1

Table of Contents