Table of Contents
Advertisement
5. After you click Open, the copyright statement of the device is displayed on the HyperTerminal. Enter a valid user name and password as
prompted to log in to the command line interface (CLI) of the device. (The information displayed in the following figure is f or reference only.)
The preset user name for the device is admin and the password is Admin@huawei.
Basic Configuration
15.3
Before configuring the parameters, determine the following data:
Parameter
Device name
Management VLAN
Service VLAN
Management IP
Management gateway IP
Service interface range
Uplink interface range
Listening port of the TCP server
Configuring Basic Network Information
1. Run the system-view command to access the system view.
2. Run the sysname RouteA command to set the device name to RouteA. By default, the device host name is Huawei.
3. Run the vlan batch 22 1001 command to create the service VLAN and management VLAN.
4. Run the vlan 22 command to access the VLAN22 view.
5. Run the description management vlan command to set the VLAN description to Management VLAN.
6. Run the quit command to exit the VLAN view.
7. Run the vlan 1001 command to access the VLAN1001 view.
8. Run the description Video command to set the VLAN description to Video.
9. Run the quit command to exit the VLAN view.
10.Run the interface vlanif 22 command to access the Vlanif22 view.
11.Run the ip address 10.0.0.1 255.255.255.0 command to set the IP address for the VLANIF interface.
12.Run the quit command to exit the VLANIF interface view.
13.Run the interface gigabitethernet 0/0/0 command to set a service interface. Access the 0/0/0 interface view and set other service ports by
referring to this interface setting.
The value of interface-number depends on the interface number. For example, if the interface number is 8, the value of interface-
number is 0/0/8. For the interface number, see the silk screen on the device port.
Interfaces 8 and 9 support the 2.5GE optical module. It is recommended that interfaces 8 and 9 be used as uplink interfaces, and
interfaces 0–7 be used as service interfaces.
14.Run the description Cam command to set the interface description to Cam.
15.Run the port link-type access command to set the interface mode to access.
16.Run the port default vlan 1001 command to set the default VLAN of the interface to 1001.
17.Run the quit command to exit the interface view.
18.Run the interface gigabitethernet 0/0/8 command to set an uplink interface. Access the 0/0/8 interface view and set other uplink interfaces
by referring to this interface setting.
19.Run the description Uplink command to set the interface description to Uplink.
20.Run the port link-type trunk command to set the interface type to Trunk.
21.Run the port trunk allow-pass vlan 22 1001 command to set the interface to allow VLAN22 and 1001 access.
22.Run the quit command to exit the interface view.
23.Run the ip route-static 0.0.0.0 0.0.0.0 10.0.0.254 command to set the default route, next hop direction, and management gateway IP
address.
Value (Example)
RouterA
22
1001 (video surveillance)
10.0.0.1
10.0.0.254
Interfaces 0–7
Interfaces 8–9
5000
14
Advertisement
Table of Contents
