Huawei ECC500 User Manual page 47

ECC500 (Data Center)
User Manual
Figure 5-15 Network Configuration
When networking modes is IP networking, you can set the ECC's IP address, subnet mask and
default gateway.
Configure SNMP northbound interface can be connected to the third-party network
management, parameters description show as in
Table 5-1 SNMP configuration parameters
Parameters
SNMP Version
SNMP Port
Issue 06 (2020-01-06)
Description

In SNMPv1&SNMPv2c system, you can set read and write
permissions of network management software to connect ECC.
 In SNMPv3 system, you can set specific users of the network
management software to connect to ECC.
 ALL: The above two are supported.
Set data port of network management software to connect the
ECC, the default value is 161.
Value range: 0–65535.
Copyright © Huawei Technologies Co., Ltd.
5 User Interface Description
Table 5-1.
41