Table of Contents
Advertisement
MAINTENANCE
LIGHT REPLACEMENT
Before replacing oven light bulb, DIS-
t
CONNECT POWER TO RANGE. Be
sure bulb is cool. Do not touch a hotbulb
with a damp cloth as the bulb may
break.
FOR NON SELF-CLEAN OVEN MOD-
ELS: Very carefully remove bulbwith a
LEVELING LEGS
dry potholderto prevent possible harm
to hands. Replace with a 40 watt appli-
OVEN DOOR
some floors are not level. For proper
baking,yourrangemustbe level, Level-
ance bulb. Reconnect power to range
Do not place excessive weight on an
ing legs are located on each corner of
and reset clock,
open oven door or stand on an open
the base of the range. Level by turning
oven door as, in some cases, it could
cause the range to tip over, breakage ol
the legs.
FOR SELF-CLEAN OVEN MODELS:
the door or serious injury.
Very carefully unscrew lense cover
_'JI
I;_'T_.
t.k,_=_
with a dry pofholder to prevent possible
harm to hands. Then very carefully re-
When opening oven door, allow steam
move bulb withadry potholder. Replace
and hot air to escape before reaching in
with a 40 watt appliance bulb. Recon-
oven to check, add or remove food.
nect power to range and reset clock.
To remove lift-off door: Open door to
the "stop" position (opened about 4
inches) and grasp door with both hands
at each side. Do not use door handle to
To prevent range from accidently tip-
_
_]_
0
liftdo°r. Lift up evenly until d°or clears
ping, range should be secured t° the
__
the hinge arms.
floor by sliding rear leveling leg into the
anti-tip bracket supplied with the range.
FUSES
(CANADIAN RANGES ONLY)
Your range is equipped with seven (7)
STORAGE DRAWER
type "P" fuses. The fuses are located on
The storage drawer at the bottom of the
the back wall. Remove the storage
range is safe andconvenientfor storing
drawer for access to the fuses.
metal and glass cookware. DO NOT
store plastic, paperware, food or flam-
mable material in this drawer. Remove
drawer to clean under range.
To remove: Empty drawer then pull
_._L_
drawer out to the first stop position. Lift
LOCATION O F
upfront Ofdrawer and pull to the second
7 FU5
stop position. Grasp sides and lift up
and out to remove drawer.
To replace: Fit ends of drawer glides
To replace door: Grasp door at each
If part of your range does not operate,
onto rails. Lift updrawer front andgently
side, align slots in the door with the
check to see if a fuse has blown. A gap
push in to first stop position. Lift up
hinge arms and slide door down onto
in the fuse strip or a darkened window
drawer again and continue to slide
the hinge arms until completely seated
indicates a blown fuse. Replacewiththe
drawerto the closed position,
on hinges,
same type and amperage type "P" fuse.
-12-
Advertisement
Table of Contents
