Servicing The Fuses; Adjusting The Safety Switches - Toro Z Master 8000 Series Operator's Manual

3. Install the battery in the machine and connect
the battery cables, refer to
(page 39).
Note:
Do not run the machine with the battery
disconnected; electrical damage may occur.
Figure 39
1. Positive battery post
2. Negative battery post
Installing the Battery
g000960
3. Red (+) charger lead
4. Black (-) charger lead

Servicing the Fuses

The electrical system is protected by fuses. It requires
no maintenance; however, if a fuse blows check the
component/circuit for a malfunction or short.
1. The fuses are located on right side behind the
seat.
2. To replace the fuses, pull out on the fuse to
remove it.
3. Install a new fuse.
Adjusting the Safety
Switches
Adjust all safety switches so that the plunger extends
4.8 mm to 6.4 mm (3/16 inch to 1/4 inch) from the
switch body when the plunger is compressed
40).
1. 4.8 to 6.4 mm (3/16 to 1/4 inch)
40
Figure 40
(Figure
g006849