Toro Z Master 8000 Series Operator's Manual page 35

Figure 31
1. Oil-fill cap
Changing the Engine Oil
Service Interval: Every 100 hours (more often in dirty
or dusty conditions).
Note:
Dispose of the used oil at a recycling center.
1. Park the machine so that the rear is slightly
lower than the front to ensure that the oil drains
completely.
2. Move the speed-control lever to the N
position to stop the machine.
3. Disengage the PTO, engage the parking brake,
shut off the engine, and wait for all moving parts
to stop.
g025758
2. Oil dipstick
EUTRAL
4. Slowly pour approximately 80% of the specified
oil into the filler tube and slowly add the
additional oil to bring it to the full mark on the
dipstick (Figure
5. Start the engine and drive to a flat area. Wait
3 minutes for oil to settle into the crankcase.
Check the oil level again
6. If needed, add oil to the full mark on the dipstick.
35
Figure 32
31).
(Figure 31).
g032754