Toro Z Master 8000 Series Operator's Manual page 23

Riding mower with 42in cutting unit
Hide thumbs Also See for Z Master 8000 Series:
Table of Contents

Advertisement

Figure 21
5. Turn the ignition key to the S
(Figure
16). When the engine starts, release
the key.
Important:
Do not crank the engine
continuously for more than 10 seconds at
a time. If the engine does not start, wait 60
seconds between starting attempts. Failure
to follow these guidelines can burn out the
starter motor.
Note:
Additional starting cycles may be
required when starting the engine for the first
time after the fuel system has been without fuel
completely.
6. If the choke is in the C
gradually return choke to the O
as the engine warms up.
g032743
position
TART
/O
position,
LOSED
N
/O
position
PEN
FF
Shutting Off the Engine
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while
it is unattended.
Always remove the ignition key and engage
the parking brake when leaving the machine
unattended, even if just for a few minutes.
Important:
Make sure that the fuel-shutoff valve
is closed before transporting or storing the
machine, as fuel leakage may occur. Engage
the parking brake before transporting. Remove
the key as the fuel pump may run and cause the
battery to lose charge.
1. Disengage the PTO.
2. Move the speed-control lever to the N
position.
3. Engage the parking brake.
4. Place the throttle in the middle position.
5. Allow the engine to run for a minimum of 15
seconds, then turn the ignition switch to the O
position to shut off the engine.
6. Remove the key to prevent children or other
unauthorized persons from starting the engine.
23
EUTRAL
FF

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

74315

Table of Contents