PowerCube 5000 (SUN2000-150KTL-S0)
Installation Guide
1.
2.
3.
4.
Figure 3-2 Drilling a hole and installing an expansion sleeve
(1) M12 bolt
(4) Expansion sleeve
Step 4 Remove the rear panel of the cabinet.
Issue 03 (2020-04-10)
Drill a hole into the concrete floor using a hammer drill. The hole depth should range
from 52 mm to 60 mm.
Slightly tighten the expansion bolt and vertically insert it into the hole. Knock the
expansion bolt using a rubber mallet until the expansion sleeve is fully inserted into the
hole.
Partially tighten the expansion bolt.
Remove the expansion bolt, spring washer, and flat washer.
Copyright © Huawei Technologies Co., Ltd.
(2) Spring washer
(5) Expansion nut
3 Installing the Cabinet
(3) Flat washer
(6) Concrete floor
22