Replacing A Pv Module - Huawei PowerCube 500 User Manual

PowerCube 500 (CPS300-N18A1H)
User Manual
5.
Step 3 Install the new lithium battery.
1.
2.
3.
4.
Step 4 Take off the protective gloves.
----End
Follow-up Procedure
Pack the faulty component and send it to the local Huawei warehouse.

6.3 Replacing a PV Module

Prerequisites

Issue 02 (2019-08-30)
Figure 6-6 Removing the old lithium battery (wall-mounted)
Loosen the screws on the hanging kit at the rear of the lithium battery and remove the
hanging kit.
Secure the hanging kit to the rear of the new lithium battery and tighten the four screws.
Install the new lithium battery.
Connect the cables to the lithium battery based on the recorded information.
Use waterproof tape to seal the cable connectors.
The protective gloves, crane, and wrench are available.
Copyright © Huawei Technologies Co., Ltd.
6 Component Replacement
52