Siemens SIMATIC Ident Function Manual page 86

Brief description of the hardware
A.2 RF180C
The table below shows the possible settings:
Table A- 5
USER_Mode
MOBY_Mode
Baud rate reader
Diagnostics with
diagnostics messages
Not permitted with MOBY D with SLG D11S/D12S
1)
Input parameters for RF180C with FB 45/FC 45
Assignment is made in UDT 10.
You will find the list of the input parameters for RF180C in the section "Parameter data block
(Page 19)".
Table of commands of the RF180C for standard addressing (FB 45)
Assignment is made in the UDT 20 by means of the "command" variable.
You will find a list and description of the commands in the section "Command parameters
(Page 30)".
Table A- 6
Number of buffers for intermediate
storage of commands and results
86
Setting of RFID-relevant parameters
Parameter name
FB 45
FB 55
FB 56
RFID standard profile
MOBY I / E standard addressing
MOBY I filehandler
MOBY U/D / RF300 / RF600
standard addressing
MOBY U filehandler
RF300 Filehandler
19.2 kBd
57.6 kBd
115.2 kBd
None
Hard errors
Hard/soft errors low priority
Hard/soft errors high priority
Number of buffers for intermediate storage
Value
No. of buffers per channel Maximum amount of data for
150
FB 45 for MOBY U, MOBY D, RF200, RF300
Function Manual, 07/2012, J31069-D0166-U001-A4-7618
Note
Default
for multitag applications
With later firmware version
With later firmware version
-
reserved
Default
(also applies to RF200)
With later firmware version
-
MOBY U/D / RF200 / RF300
MOBY U/D / RF200 / RF300
MOBY U/D / RF200 / RF300
Standard diagnostics only
Hardware-related messages only
All messages
All messages high-priority
intermediate storage
34 950 bytes
1)
1)