Operation; Maintenance; Optional Accessories; Protecting The Environment - DeWalt D25301D Original Instructions Manual

OPERATION

WARNING: To reduce the risk of
serious personal injury, turn tool
off and disconnect battery pack or
power source before making any
adjustments or removing/installing
attachments or accessories. An
accidental start-up can cause injury.
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: Always read and operate
the tool as instructed in the tool
instruction manual.
Setting the Drilling Depth (fi g. 5)
Press the depth adjustment button (d) on top of the
front slider and move it to the desired drilling depth.
Release the button.
Adjusting the Drill Length (fi g. 4, 6)
1. Insert the appropriate drill bit.
2. Hold the dust extraction head (e) against a wall
(fig. 4).
3. Push the tool to make the drill bit touch the
surface.
4. Press the length adjustment button (c) on top
of the back slider and move it to the desired
length. Release the button.
5. Gently withdraw the tool assembly from
the wall, taking care that the spring-loaded
mechanism does not release.

MAINTENANCE

WARNING: To reduce the risk of
serious personal injury, turn tool
off and disconnect battery pack or
power source before making any
adjustments or removing/installing
attachments or accessories. An
accidental start-up can cause injury.
Your D WALT dust extraction telescoping system
E
has been designed to operate over a long period of
time with a minimum of maintenance. Continuous
satisfactory operation depends upon proper care
and regular cleaning.
WARNING: Use only D
replacement parts.
Replacing the Dust Brush (fi g. 7)
The dust brush will wear during use and will need to
be replaced.
1. Remove the circlip (k) using a pair of circlip
pliers.
2. Replace the dust brush (f).
3. Refit the circlip.
Cleaning

Optional Accessories

Consult your dealer for further information on the
appropriate accessories.

Protecting the Environment

WALT
E
Should you find one day that your D
needs replacement, or if it is of no further use to you,
do not dispose of it with household waste. Make this
product available for separate collection.
WARNING: Wear approved eye
protection and approved dust mask
when performing this procedure.
WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.
WARNING: Since accessories, other
than those offered by D WALT, have
E
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only D WALT, recommended
E
accessories should be used with this
product.
Separate collection. This product must
not be disposed of with normal
household waste.
WALT product
E
EN GL IS H
17