Specifications - National Instruments CompactRIO NI cRIO-9012 Operating Instructions Manual

USER1 LED
You can define the USER1 LED to meet the needs of your application.
To define the LED, use the RT LEDs VI in LabVIEW. For more
information about the RT LEDs VI, refer to the LabVIEW Help.
Resetting the Network Configuration of the Controller
If the controller is not able to communicate with the network, you can use
the IP RESET switch to manually restore the controller to the factory
network settings. When you restore the controller to the factory network
settings, the IP address, subnet mask, DNS address, gateway, and
Time Server IP are set to
settings, and VIs are unaffected.
Complete the following steps to reset the controller.
1.
2.
3.
The network settings are restored. You can reconfigure the settings in
MAX from a computer on the same subnet. Refer to the Measurement &
Automation Explorer Help for more information about configuring the
controller.
Note If the controller is restored to the factory network settings, the LabVIEW run-time
engine does not load. You must reconfigure the network settings and restart the controller
for the LabVIEW run-time engine to load.

Specifications

The following specifications are typical for the range –40 to 70 °C unless
otherwise noted.
Network
Network interface ...................................10BaseT and 100BaseTX
Compatibility ..........................................IEEE 802.3
Communication rates ..............................10 Mbps, 100 Mbps,
Maximum cabling distance.....................100 m/segment
cRIO-9012/9014 Operating Instructions and Specifications
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
0.0.0.0
Move the IP RESET DIP switch to the ON position.
Push the RESET button to cycle power to the controller. The STATUS
LED flashes once, indicating that the controller IP address is
unconfigured.
Move the IP RESET switch to the OFF position.
12
. Power-on defaults, watchdog
Ethernet
auto-negotiated
ni.com