Table of Contents
Advertisement
Maintenance
Important:
All electrical repairs should be performed by
an authorized Toro distributor only.
The operator can perform very little maintenance other than
protecting the charger from damage and weather.
Maintaining the Cords
•
Clean the cords with a slightly damp cloth after each use.
•
Coil the cords when not in use.
•
Periodically examine the cords for damage, and replace them
when necessary with Toro-approved parts.
Cleaning the Case
Clean the case with a slightly damp cloth after each use.
Service
This charger is a solid-state device and should not require service
under normal operating conditions and use according to these
instructions. Should it need service, bring the charger to an
authorized Toro distributor. Repair by service centers not operated
by Toro may result in damage to connected equipment and is
not covered under the warranty.
Storage
1.
Complete the procedure for
(page
6).
2.
Disconnect the power supply cord from the charger and coil
it securely.
3.
Examine the power supply cord thoroughly for signs of wear
or damage. Replace it if it is worn or damaged.
4.
Examine the charger thoroughly for worn, loose, or damaged
parts. To repair or replace parts, contact your authorized
Toro distributor for assistance.
5.
Store the charger with the power supply cord in a clean,
dry place where it will not be bumped or damaged and not
exposed to caustic fumes.
Disconnecting the Charger
7
Advertisement
Table of Contents
