Disconnecting The Charger - Toro 04065 Operator's Manual

3. Turn the power to the machine off
4. Pull the T-handle connector off the main battery power
supply connector affixed to the battery tray
1. T-handle connector
5. Clean and dry both the battery pack and charger connectors.
Important:
Do not use strong solvents that degrade
the strength of the connector plastic. Do not use
dielectric grease on the connector or battery contacts.
6. Align the positive connectors (marked with a "+") and push
together until they lock.
WARNING
Battery charging is dangerous when done improperly.
If there are workers present while a battery pack is
charging, designate a person to supervise the area
and ensure compliance with all safety instructions
contained in this manual. That person shall:
•
Be alert to people that come into the area and the
equipment they are using.
•
Stop any unsafe activities and prevent any unsafe
conditions.
•
Do not allow activity near the charger or battery
pack that might result in either being bumped or
knocked over.
•
Do not allow the operation of any equipment that
could produce a spark or flame or discharge water
or other liquids on or around the battery pack or
charger.
(Figure 1).
(Figure
Figure 3
2. Main power supply
connector on the battery
platform
Monitoring the
Charging Process and
3).
Troubleshooting
Note:
The LCD status display displays messages during the
course of charging. Most are routine.
If there is a fault, the error indicator light will flash amber, or light
solid red. An error message will appear in the LCD display
1) 1 digit at a time, starting with the letter E or F (for example,
E-0-1-1).
To correct an error, refer to
of these solutions correct the issue, contact an authorized Toro
distributor.
Completion of the Charging
Process
When charging is complete, the battery charging indicator light
shows solid green
g259735

Disconnecting the Charger

1. Disconnect the charger T-handle connector from the main
battery power supply connector affixed to the battery tray.
Important:
2. Place the charger T-handle and cord in a storage position
that will avoid damage.
3. Ensure that the T-handle and battery pack connectors are
clean.
4. Connect the T-handle to the battery pack connector
3)
5. Turn on machine power (See the Operator's Manual) and
verify battery charge displayed on the InfoCenter matches
that as stated on the charger.
6
Troubleshooting (page
(Figure 1).
Do not pull on the cables
(Figure
8). If none
(Figure