Add Panasonic Tv Devices - Panasonic ISE SMART CONNECT KNX Product Manual

9.2

Add Panasonic TV devices

Each TV device in the network requires a permanent IP address or a permanent host name so that it can
be identified. It is essential to assign the IP address or host name.
Set the TV device IP address as follows:
• Press the <<MENU>> button on the TV device remote control.
• For a WLAN connection, select <<Network>>
<<Manual>>
button.
• For a cable connection, select <<Network>>
<<Manual>>
• The IP/DNS settings are displayed and the settings for IP address, subnet mask,
standard gateway and DNS address can be configured.
• The aforementioned steps may vary depending on TV model.
Important
In order to guarantee communication between the ISE SMART CONNECT KNX Panasonic and
the TV device, switch the TV device on manually before initial commissioning.
Configure the following settings under <<Menu/Network/TV Remote Settings>>:
• TV Remote = on
• Networked Standby = on
Parameter
<<Panasonic TV device identified
using>>
<<IP address>>
<<Panasonic TV device's host
name>>
Table 13: Parameters under <<Panasonic TV device<n>>> tab
ISE SMART CONNECT KNX Panasonic
© 2019 ise Individuelle Software und Elektronik GmbH
→ <<Radio connection>>
→ <<Cable connection>> and confirm with the <<OK>> button.
Selects whether the TV device is addressed via the fixed
IP address or the host name.
Enter the TV device's fixed IP address.
►
See figure 23, IP address under <<Settings>> tab.
Enter the Panasonic TV device's host name.
• Do not use any special characters in the host name.
• Use a different host name for each TV device. Using
the same host name leads to undefined behaviour.
• If the host name is changed, please disconnect the TV
device from the network or restart the ISE SMART
CONNECT KNX Panasonic.
►
See figure 24, Host name under <<Settings>> tab.
Configuring Parameters
→ <<Network connection>>
→ <<Yes>> and confirm with the <<OK>>
→ <<Network connection>>
Description
→
→
1-000C-000
S. 41 / 69