Panasonic ISE SMART CONNECT KNX Product Manual page 19

Important
Functional fault in all devices due to incorrectly dimensioned power supply
The following applies if you use the non-choked auxiliary supply output of a KNX power supply
as an additional power supply:
The operating currents of all KNX/TP devices on the line section must not exceed the rated cur-
rent of the power supply.
4. Attach the cover cap supplied:
a. Route all cables to the back. The openings for fastening the cover cap (see figure 10, item 1)
must be clear. All cables must be between the openings.
Figure 10: Cable routing
b. Attach the cover cap over the connection terminals.
c. Press the cover cap together gently.
d. Route the cover cap's fastening claws into the openings until the cover cap noticeably
engages.
Figure 11: Attaching the cover cap
ISE SMART CONNECT KNX Panasonic
© 2019 ise Individuelle Software und Elektronik GmbH
Installation
1-000C-000
S. 19 / 69