Checking And Clearing Alarms - Toro DEC-RS-1000-DR Installation And User Manual

Checking and Clearing Alarms

Press the down arrow key
the stations with alarms. To clear the alarm, press the right arrow key
to display Clear Alarm. Press the down arrow key
Menu: RunDiagnostics
Perform: Comm Check
Press START to start
Menu: VA Monitor
Battery Volt: 3.3
LCD Voltage: 2.7
Board temp: 28c
Menu: Event Codes
Clear log: No
Last code: 93
06/30/11 10:21:46
26
to advance the cursor to the S001: field. Use the input dial
to execute.
Use this menu perform a
Comm (Communication)
Check or a Solenoid Chk
(check).
Use this menu to monitor the
system's voltages.
This menu will display the last
logged event that may help
diagnose problems. The event
code, date and time the event
occurred will be displayed. Clear
the log by navigating to "Clear
log: No" using the Right or Left
arrows .
Use the input dial to toggle No
to Yes. Press the Up or Down
arrow to accept.
to the Alarm: field, use the Input Dial
Menu: Revision
Revision: 02.08
Rev. Date 01/04/11
Menu: PowerUp Detect
,
Capacity: 200 sta s
PD 06/28/11 13:53:51
PU 06/29/11 11:15:32
Menu: Link Monitor
Sent: GetPumpPress
Resp: 2nd
Total Bad Resp: 001
Total Timeouts: 001
Total Failed: 002
Clear Total: No
1st Line: Name of the sent message
2nd Line: Response status
3rd Line: Number of messages that were sent out with bad responses
4th Line: Number of messages that did not get a response
5th Line: Number of messages that failed to communicate after
Use the arrow keys to navigate to Clear Total and toggle
No to Yes to clear all Link Monitor's values.
to scroll through all
Use this menu to
verify firmware
version.
This menu will display
the detected station
capacity from the last
Power Down (PD).
PU will display the date
and time of the last
Power Up.
Use this menu to display
when and what messages
are sent.