Spare Parts; Troubleshooting - enware LEVA Installation Instructions Manual

CLEANING
Enware Product should be cleaned with a soft damp cloth using only mild liquid detergent or soap
and water. Do not use cleaning agents containing a corrosive acid, scouring agent or solvent
chemicals. Do not use cream cleaners, as they are abrasive. Epoxy coated surfaces should only be
cleaned with a cloth and clear water or mild detergent. Use of unsuitable cleaning agents may
damage the surface. Any damage caused in this way will not be covered by warranty.

SPARE PARTS

Component
Sequential Cartridge Kit (Incl. Cartridge, spacer bush, spindle adaptor, retaining nut)
LEVA Handle 80mm
Wall Trim
Colour Indicator Pack (1x Yellow, 1x Grey, 1x Blue, 1x Red)
Basin Mixer Body Assembly
Grub Screw Pin

TROUBLESHOOTING

Problem
Tap is dripping water
Water is leaking from spindle
Water is not flowing from tap
Handle is wobbly
Handle feels loose
Cause
Debris is caught inside cartridge
Cartridge is worn or damaged
Pressure too high
Seal in Cartridge is worn or
damaged
Pressure too high
Water turned off
Spacer bush is missing
Spindle adaptor not adjusted
correctly
Enware Product Code
LEVSQSBA
LEVSQ80378
LEVSQBFLAN
LEVSQIND
LEVSQBMIX
673480
Rectification
Remove and flush Cartridge,
inspect and remove any debris.
Replace Cartridge if damaged.
Install pressure reduction valve,
ensure it is under 500 kPa
Replace Cartridge
Install pressure reduction valve,
ensure it is under 500 kPa
Turn water on
Install Spacer Bush
Adjust spindle adaptor – refer
to handle fitting instructions
10