Update Time; Average % Days; My Location; Signal Strength - Toro EVOLUTION Series Manual

1. Press or to increase or decrease the percentage
of irrigation runtime.
2. Press to input the value.
It is possible to disable the Water Adjust feature.
Lowering the number below -35% or above +35% will
show OFF. (The sensor will continue to operate as a rain
and temperature sensor.)
Press the to input the value.
Low Limit
This feature allows the user to set the lowest level that the
sensor will allow the controller to adjust. The default is OFF
but can be adjusted to -99% to -50%. Meaning, if the sensor
was going to make a -90% adjustment, but the Low Limit was
set to -70, the controller would water at -70%.

Update Time

This is the time at which the sensor will update the controller
with new ET data. If irrigation were to commence at 6am, for
example, it might be advantageous to have ET data sent to the
controller at 5:45am to optimize watering runtimes.
1. Press or to adjust the hour, minute, and AM/
PM fields.
2. Press or to switch from one field to another.
3. Press to input the value.

Average % Days

This is the previous number of days from which the sensor
will use to generate an average runtime value. This is done to
minimize the impact of unseasonably cold or hot days. Values
range from 1-7 (days).
1. Press or to change the number of days.
2. Press to input the value.

My Location

Setting the My Location is necessary for ET data to work. It
is possible to set the location by either U.S. ZIP Code or by
Latitude and Longitude. (See Step 7 illustration, page 6.)
WEATHER SENSOR
AVERAGE % DAYS
ID
MY LOCATION
MY LOCATION

SIGNAL STRENGTH

BATTERY LEVEL

1. To adjust TYPE, press
to select LONG/LATor ZIP CODE.
Press
2. Press . Adjust Zip Code or Latitude and Longitude
values with the and
GOOD
to move to ZIP CODE.
buttons.
11