Advertisement
4
Adjusting the Cargo-Box
Latches
No Parts Required
Procedure
If the cargo-box latch is out of adjustment, the cargo box
vibrates up and down as you drive the machine. You can
adjust the latch posts to make the latches hold the cargo box
snugly to the chassis.
1. Verify that the cargo box is latching.
Note: If the cargo box does not latch, the box-latch
striker is likely too low. If the cargo box latches, but
vibrates up and down as you drive, the box-latch striker
is likely too high.
2. Pull on the lever on the left, inside of the cargo box
toward you and lift the cargo box up
1. Cargo-box lever
3. Pull the prop rod into the dump position detent slot,
securing the box in a dumping position
(Figure
6).
Figure 6
(Figure
1. Service position detent
slot
2. Prop rod
4. Loosen the 2 bolts on the box-latch striker and move
the striker up or down, depending on if the striker is
too high or too low
1. Bolt
5. Tighten the 2 bolts on the box-latch striker
g034019
6. Verify that the adjustment is correct by latching the
cargo box several times.
7).
4
Figure 7
3. Dump position detent slot
(Figure
8).
Figure 8
2. Box-latch striker
(Figure
g034021
g034451
8).
Advertisement
