Specifications; General Specifications - Toro Reelmaster 5200-D Operator's Manual

Specifications

General Specifications

Kubota three cylinder, 4 cycle liquid cooled diesel engine. 25 hp @ 3000 rpm for
Reelmaster 5200 and 31.5 hp @ 3000 rpm for Reelmaster 5400. Both governed to
Engine
3200 rpm. 68.5 cu. in. (1123 cc) displacement. Heavy duty, 3-stage, remote
mounted air cleaner. High water temperature shutdown switch.
Radiator capacity is approximately 7-1/2 qt. of 50/50 mixture of ethylene glycol
Cooling System anti-freeze. Remote mounted 1 qt. expansion tank. A two speed fan drive controls
air flow from fan.
Fuel tank capacity is 9.5 gal. of #2 diesel fuel. Equipped with a fuel filter/water
Fuel System
separator to capture water in the fuel.
Foot pedal controls forward/reverse ground speed. Ground speed: 0–10 mph
forward and 0–4 reverse. Hydrostatic transmission mounted directly on a 20.9:1
Traction System
ratio front axle. Axle/reservoir capacity is 5 qt. Replaceable filter mounted directly
on transmission housing. Model 03544 only—mechanical rear axle is coupled to
front axle by a driveshaft and overrunning clutch.
Hydraulic reel motors feature quick disconnects to ease removal/installation on
Cutting Unit Drive System cutting units. Hydraulic fluid reservoir capacity is 8 gal. System protected by a filter
assembly with service indicator.
Deluxe high back seat with adjustable fore and aft travel, weight and height. Tool
Seat
box at left side of seat.
Steering System Power steering with dedicated power source
Two rear tires: 20 x 10.00-10, tubeless, 6-ply rating. Two front tires: 26.5 x 14.00-12
Tires tubeless, 4-ply rating. Recommended tire pressure for front and rear tires is 10–15
psi.
Individual drum type wheel brakes on front traction wheels. Brakes controlled by
Brakes individual pedals operated by the left foot. Hydrostatic braking through traction
drive.
Automotive type electrical system. 12 volt, maintenance free battery with 530 cold
cranking Amps @ 0 degrees F. and 85 minute reserve capacity @ 85 degrees F. 40
Electrical System
amp alternator with I.C. regulator/rectifier. Seat switch, reel and traction interlock
switches. An electronic controller monitors and controls safety and operational
functions. Parking brake switch in steering column.
Foot operated traction and brake pedals. Hand operated throttle, traction speed
control lever, parking brake lock, ignition switch with automatic preheat cycle, single
Controls
joy stick control for cutting unit on/off and lift/lower. Cutting unit backlap switch and
reel speed controls located under control console.
Hour meter, speedometer, fuel gauge, temperature gauge. 4 warning lamps: oil
Gauges
pressure, water temperature, amps, and glow plug.
The Automatic Control Electronics, ACET system allows precise timing and control
of machine functions for maximum reliability. Optional hand held diagnostic display
Diagnostics
connects to an electronic control unit to pin point any electrical problems quickly
and easily. Available DATA LOG™ system allows mechanic to find intermittent
problems.
12