Siemens SINUMERIK 840DE sl Commissioning Manual page 102

Channel menu
6.5 Configuring operating stations in the "config.ini" file
"netnames.ini" file
A channel group, e.g. channel group 1 is therefore specified as follows:
[CH_GRP_1]
Text = Process1
Member1.Target =
[<HMI>.]<NC>.#<channel
number>
Member<No>.Text = NCU730_K1
Member2.Target =
Member2.Text
6.5 Configuring operating stations in the "config.ini" file
The version of the channel menu is individually defined for the operator stations in the
"config.ini" files belonging to the station. The data defined in the "netnames.ini" file is used.
Here, the channel groups are assigned a softkey in the channel menu.
88
; Name of the channel group; the notation
; must follow this scheme. The groups are
; consecutively numbered at the last
; position.
; Softkey text for the channel group for
; display in the channel menu (horizontal
; softkey) switchover designation 1 of the
; channel group.
; Computer name (host name) or the IP
; address of the computer on which the HMI
; to be selected runs (NCU or PCU):
; <HMI> = <IP address or name of the HMI
; host (PC/PCU)>
; <HMI> can be omitted if the HMI runs
; locally on the NCU
; <NC> = <IP address or name of the NC>
; Alternatively, the machine name can also
; be specified from the mmc.ini.
; Using ".#Channel number", optionally the
; NC channel can be specified that should
; be taken when switching over.
;
; Softkey text for the display in the
; channel menu (vertical softkey). If, for
; "Target" a channel number is specified,
; then instead of a text, using the fixed
; value "$MC_CHAN_NAME", it can also be
; defined that the text to be displayed
; should be the channel name defined in the
; NCK machine data.
;
; Same as for the vertical softkey 2
Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
SINUMERIK Operate (IM9)