Reinstallation - FujiFilm SP-3000 Service Manual

4.3

Reinstallation

The device driver installation and system
reinstallation procedures must be performed if the
main control unit or hard disk has been replaced, or
after reinstallation of "OS Windows 2000" using the
Recovery CD
(See Subsection 3.5.1)
When system reinstallation into the present main
control unit is necessary, perform the folder renaming
and reinstallation procedure. The device driver
installation is unnecessary.
Perform these operations after turning OFF the
scanner.
●Device Driver Installation
Perform this operation after replacing the main control
unit or hard disk, or installation of "OS Windows 2000"
using the Recovery CD.
1. Turn the power switch ON to start up the Printer/
Processor and then to STANDBY.
2. Press the START switch of the Scanner.
3. Immediately after the Scanner starts up, insert the
driver disk into the CD-ROM drive.
• The "Found New Hardware Wizard" screen
appears.
NOTE: The "Device Driver Disk [D-01]" dialog box may
appear over the "Found New Hardware Wizard"
screen.
4. Click the [Cancel] button of the "Found New
Hardware Wizard" screen.
• The second "Found New Hardware Wizard"
screen appears.
5. Click the [Cancel] button of the "Found New
Hardware Wizard" screen.
Distributed by minilablaser.com
.
4-13
Driver Disk
4
Z2043