Pac23 Circuit Board Replacement - FujiFilm SP-3000 Service Manual

19.2 Power Supply/Electrical Equipment Section
7. Secure the upper harnesses with the two clamps
on the image control section as shown.
8. Secure the white/black harnesses with the clamp
on the right wall as shown.
9. Pull out the bracket.
Reinstallation
Reinstallation is essentially in the reverse order of
removal.

19.2.3 PAC23 Circuit Board Replacement

Removal
1. Remove the AC power supply bracket
.
(See Subsection 19.2.2)
2. Disconnect the six connectors (PAC2, PAC9 to
PAC12 and PAC17).
3. Remove the seven screws and then the circuit
board.
Installation
Installation is essentially in the reverse order of
removal.
Distributed by minilablaser.com
Clamps (2)
Connectors (6)
19-6
Clamp
LII1185
PAC23 Circuit Board
Screws (7)
LII858