FujiFilm SP-3000 Service Manual page 120

3.2 Messages and Actions
No. Message
W-2680 Number of prints exceeds limit.
Stop printing.
Press [Help] button to see error help
(or manual). Mix replenisher while
referring to it.
I-2681 Mixing replenisher.
Please wait.
I-2682 Processor busy. Auto-washing of
racks in process.
Please wait.
I-2684 Processing paper.
Please wait.
E-2685 Error occurred in replenishment
section.
Shut down scanner with emergency
stop button and restart it. If problems
persist, consult your technical
representative.
I-2689 Last replenishment solution
prepared.
Replace replenisher cartridge.
I-2690 Processing paper.
Please wait.
Perform control strip processing after
paper processing.
I-2691 Solution remains in replenisher tank.
Shut down scanner with emergency
stop button and restart it. If problems
persist, consult your technical
representative.
I-2692 Intermittent operation.
Please wait.
I-2693 Processor section now operating.
Please wait.
I-2694 Temperature adjustment of
processing tanks is process.
Please wait.
Distributed by minilablaser.com
Factor
Accumulated output amount of P1R
replenisher exceeds the specified
range.
(Causes of the error message)
1. Error in the replenishment system
has not been solved.
A specified amount of processing is
performed while mixing new
replenisher
Auto-washing of racks is in progress.
Pre-operational or post-operational
check is attempted while printing.
System is started up but the
replenishment section is in an error
state.
Last cartridge opening is detected.
Control strip processing is performed
during paper processing.
Replenisher tank lower level sensor
detects "Solution exists".
(Causes of the error message)
1. At the time of installation, when
solution mixing is performed again
after error recovery, a lower level
sensor detects "Solution exists"
because solution remains in the
replenisher tank.
2. Faulty lower level sensor (FS724/
FS725/FS726)
Auto intermittent driving is in
progress.
1. Auto-washing is attempted during
paper processing.
2. Auto-washing is attempted during
control strip processing.
–
3-59
Actions
1. Perform Menu 0123 "Error
Information Check" to solve the
error, and then take appropriate
corrective measures. (See
Subsection 3.3.12)
–
–
Wait until processing is completed.
1. Perform Menu 0123 "Error
Information Check" to solve the
error, and then take appropriate
corrective measures. (See
Subsection 3.3.12)
–
–
1. Drain solution remaining in the
replenisher tank.
2. Replace FS724/FS725/FS726.
–
–
–
3