Installation; Appropriate Installation Location; Connecting Water Supply - Blomberg LDV42124 User Manual

Installation

3
To make the product ready for use,
make sure that the electricity, tap
water supply and water drainage
systems are appropriate before calling
the Authorised Service Agent. If they
are not, call a qualified technician
and plumber to have any necessary
arrangements carried out.
C
Preparation of the location
and electrical, tap water and
waste water installations
at the place of installation
is under customer's
responsibility.
B
Manufacturer shall not
be held responsible for
damages arising from
processes carried out by
unauthorised persons.
A
Prior to installation, visually
check if the product has any
defects on it. If so, do not
have it installed. Damaged
products cause risks for your
safety.
C
Make sure that the water
inlet and discharge hoses
are not folded, pinched or
crushed while pushing the
product into its place after
installation or cleaning
procedures.
When placing the product, pay attention
not to damage the floor, walls, piping,
etc. Do not hold the product from its
door or panel to move it.
Appropriate installation
location
• Place the product on a solid and
flat floor that has sufficient load
Dishwasher / User manual
carrying capacity! The product
must be installed on a flat surface
in order for the door to be closed
comfortably and securely.
• Do not install the product at places
where temperature may fall below
0ºC.
• Place the product on a rigid floor.
Do not place it on a long pile rug or
similar surfaces.
B
Ensure the power cable does
not get trapped under the
product.
• Make sure that you select a
location that will allow you to load
and unload the dishes in a fast and
comfortable manner.
• Install the product in a place close
to the tap and the drain. Select the
installation location by considering
that it will not be changed after the
connections are made.

Connecting water supply

• Do not use old or used water inlet
hose on the new product. Use the
new water inlet hose supplied with
the product.
• Connect the water inlet hose
directly to the cold water tap.
Permitted water temperature up
to 25°C. Pressure coming from
the tap should be minimum 0.3
and maximum 10 bars. If the
water pressure exceeds 10 bars,
a pressure relief valve should be
installed in between.
• Open the tap completely after
making the connections to check
for water leaks.
9 / 45 EN