Table of Contents
Advertisement
3
Installation
Refer to the nearest Authorised
Service Agent for installation of your
product. To make the product ready
for use, make sure that the electricity,
tap water supply and water drainage
systems are appropriate before calling
the Authorised Service Agent. If they
are not, call a qualified technician
and plumber to have any necessary
arrangements carried out.
C
Preparation of the location
and electrical, tap water and
waste water installations at
the place of installation is
the customer's responsibility.
B
Installation and electrical
connections must be carried
out by the Authorised
Service Agent. Manufacturer
shall not be held responsible
for damages arising from
processes carried out by
unauthorised persons.
A
Prior to installation, visually
check if the product has any
defects on it. If so, do not
have it installed. Damaged
products cause risks for
your safety.
C
Make sure that the water
inlet and discharge hoses
are not folded, pinched or
crushed while pushing the
product into its place after
installation or cleaning
procedures.
When placing the product, pay
attention not to damage the floor, walls,
piping, etc. Do not hold the product by
its door or panel to move it.
Dishwasher / User manual
Appropriate installation location
•
Place the product on a solid and
flat floor that has sufficient load
carrying capacity! The product must
be installed on a flat surface in order
for the door to be closed comfortably
and securely.
•
Do not install the product at places
where temperature may fall below
0ºC.
•
Place the product at least 1 cm away
from the edges of other furniture.
•
Place the product on a rigid floor.
Do not place it on a long pile rug or
similar surfaces.
B
Do not place the product on
the power cable.
•
Make sure that you select a location
that will allow you to load and unload
the dishes in a fast and comfortable
manner.
•
Install the product in a place close to
the tap and the drain hole. Select the
installation location by considering
that it will not be changed after the
connections are made.
Connecting water supply
C
We recommend attaching
a filter on the house/
apartment supply water
inlet to protect the machine
from damages that may
arise from impurities (sand,
dirt, rust, etc.) coming from
the urban water supply
system or from your own
water system as well as to
prevent complaints such
as yellowing or sludge
accumulation at the end of
washing.
9 / 47 EN
Advertisement
Table of Contents
