Before First Use; Warning; This Appliance Must Be Earthed; Electrical Requirements - Blomberg GSN 9120 Instruction Manual

Iron and cast iron objects can rust and
stain other items.
Pay special attention to whether or not
the item you wash in the dishwasher is
dishwasher-proof.
If in doubt, contact the manufacturer of
the item.
Do not overload your dishwasher or
do not load items other than those
mentioned in this manual.
3

Before first use

After unpacking your dishwasher, check
the machine against any possible
transportation damage. Never install
and use damaged machines. If your
machine is damaged contact your
retailer. Always have your machine
installed by qualified electrician/plumber
to ensure correct installation.
Any repairs and maintenance work
on this dishwasher should be carried
out by authorised service staff only.
Unauthorised repairs are not only
dangerous, but also lead to the
cancellation of your warranty.
Make sure the electricity and water
connections of your dishwasher are
in compliance with the instructions for
assembly as stated in the relevant part
of this booklet.
Any water remaining in the dishwasher
after production should be carefully
removed due to reasons of hygiene.
Therefore, always select a pre-wash
programme before first use
(Pre-wash or Economy programme).
Before the first wash, add 1 lt of water
to the salt container of your machine.
4

Installation

When deciding on where to install
your new dishwasher, ensure that the
position of your dishwasher makes it
easy and quick for you to place the
dishes in the dishwasher and also to
take them out and store away after the
dishwashing is completed.
Avoid placing the dishwasher where
the ambient temperature is likely to fall
below. 5 degrees C. (41° F)
When positioning your appliance, take
care not to damage your flooring, pipes
wall coverings etc. Do not move the
appliance by pulling by the door or
handle

Electrical requirements

Before you insert the plug into the wall
socket make sure that the voltage and
the frequency shown in the rating label
corresponds to your electricity supply.
We recommend that this appliance be
connected to the mains supply via a
suitable switched and fused socket in a
readily accessible position.
If the supply cord or the mains lead
is damaged please do not replace
it by your own. The supply cord or
the mains lead must be replaced by
a Beko Authorized Service Agent
personnel or a similarly qualified
person.

Warning

This appliance must be
earthed
If the fitted moulded plug is not suitable
for your socket, then the plug should
be cut off and an appropriate plug
fitted.
9 GB