Page 2
Dear Customer, Please read this user manual before using the product. Thank you for choosing this Blomberg product. We hope that you get the best results from your product which has been manufactured with high quality and state-of-the-art technology. Therefore, please read this entire user manual and all other accompanying documents before using the product.
This product must be used to Safety Instructions do the domestic type dishes • This section contains safety only. instructions that will help get This product is not suitable for protected against risks of commercial or collective use. personal injury or property damage.
door should not be left in the excessively, pinched or come open position since this could into contact with any heat present a tripping hazard. sources. Cleaning and user Do not use extension cords, maintenance works should multi-sockets or adapters to not be performed by children operate the product.
NOTICE Make sure that cause hot steam to escape. the hoses do not get kinked, Otherwise, it might cause squeezed or crushed while serious burns and injuries, placing the product into its and harm your furniture. location after installation or Do not install the product cleaning procedures.
new hose set provided with the the door of the product will product. Do not reuse the old bear all the weight of the hose set. Do not make extension baskets. Do not sit or put at the hoses. other loads on the door; otherwise, the product may NOTICE Connect the water inlet tilt.
the tap if you are not going to use it for a long time. Maintenance and cleaning safety Do not wash the product by spreading or pouring water onto it. Do not use sharp or abrasive tools when cleaning the product.
Environmental Compliance with RoHS Directive Instructions The product you have purchased complies with EU RoHS Directive Compliance with WEEE (2011/65/EU). It does not contain Directive and Disposing of harmful and prohibited materials the Waste Product specified in the Directive. This product complies with EU WEEE Directive (2012/19/ Package information EU).
Page 10
Note for test institutions: Frequency Band : 2.400-2.484 Ghz Data required for performance tests shall Max. Transmission Power : < 100mW be provided upon request. Requests can Conformity declaration for be e-mailed to the following address: UKCA dishwasher@standardloading.com Do not forget to provide the code, stock number and serial number of the product ARÇELİK hereby declares that this to be tested in your request e-mail along...
Technical specifications Maximum washing capacity (check the energy label and Programme data and average consumption values table given on Quick Guide. ) Height (check installation document for installation) Width: 60 Depth: 57 Power input: 220-240 V, 50 Hz * Total power 1800-2100 W * Heater power: 1800 W * Total current: 10 A * Pump power: 90 - 125 W *...
Installation Appropriate installation location In the area where this product is Read “Safety Instructions” section first! installed, there must not be a lockable, Installation procedures must always be sliding or hinged door that will restrict performed by the manufacturer, authorised full opening of the product’s door.
aquAvoid™ plus Permitted water temperature: up to 25°C ( 60°C for products equipped (depends on the model) with aquAvoid™ plus; please refer The aquAvoid™ plus system protects to aquAvoid™ plus section ) against water leaks that may occur at the The dishwasher may not be connected to hose inlet.Water contact with the valve box open warm water devices or flow-through...
Connection to the drain Electrical connection Water discharge hose can directly be Connect the product to a grounded connected to the drain hole or sink’s outlet protected by a fuse complying drainage. See the installation manual with the values in the "Technical supplied with your machine for detailed specifications"...
pin face of the plug. Fuse covers are available from any good electrical store. Fitting a different plug As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals on your plug, proceed as follows: Connect the green - yellow or green (earth) wire to the terminal in the plug...
Preparation Read “Quick Guide - Adjusting Water Softening System” before this section! The regeneration of the water softening Read “Safety Instructions” section first! system can be done in all programmes Tips for energy saving during drying step. When regeneration occurs, duration, energy and water Following information will help you use the consumption of the programme increase.
Adding salt Water softening system needs to be regenerated in order for the product to operate with the same performance continuously. Dishwasher salt is used for this purpose. Use only special softening salts produced particularly for the dishwashers in your machine. You can put about 2 kg of softening It is recommended to use granule- or salt into the salt reservoir.
Page 19
Adding detergent Pay attention to the warnings on the detergent packaging to get better washing and drying results. Contact the manufacturer of the detergent for further questions. Do not put solvents into the detergent dispenser. There is the risk of explosion! 3.
Tablet detergents 3. After the empty washing cycle, review the user manual and readjust the water In addition to the conventional tablet hardness level so as to suit the water detergents, there are also commercially supply. available detergent tablets that show water 4.
3. Slightly press the point (B) of the Decorative prints of chinaware as well reservoir lid to close it. as aluminium and silver items may get discoloured or tarnished after washing in the dishwasher just as it happens in handwashing as well. Some delicate glass types and crystals may become dull in time.
Page 22
Suggestions for loading the dishwasher Improper Loading Of Dishware Lower basket Upper basket Improper Loading Of Dishware 22/EN...
Cutlery basket Cutlery basket (depends on model) (depends on model) Cutlery basket is designed to wash your Cutlery basket is designed to wash your dishes such as knife, fork, spoon, etc. in an dishes such as knife, fork, spoon, etc. in an efficient manner.
Collapsible lower basket tines Collapsible lower basket tines (depends on model) (depends on model) There are foldable tines (A) located at There are foldable tines (A) located at the lower basket of the machine are the lower basket of the machine are designed for an easier placement of large designed for an easier placement of large pieces such as pans, bowls, etc.
Upper basket height adjustable Collapsible upper basket wires rack (depends on model) You can use collapsible wires when you (depends on model) need a larger space for your dishes in the Use the lower and upper parts of the height upper basket of your machine.
Adjusting the height of the upper Repeat the same operation if the height is not adequate. basket (depends on model) Upper basket height adjustment mechanism is designed so that you can create wide spaces on the upper or lower compartment of the machine by adjusting the basket upwards or downwards either while it is empty or full.
Ceiling cutlery basket (depends on model) Ceiling cutlery basket is designed to wash your cutlery items such as forks, spoons and etc. by placing them between the bars on the basket. When the central tray is in the lower position, you can load long/high items such as coffee cups, ladles, etc.
Operating the product Programme selection Read “Safety Instructions” section first! 1. Press the On/Off button to turn on your Read “Quick Quide” before this machine. section. 2. Check the Salt and Rinse Aid indicators On/Off key and add salt and/or rinse aid if needed. When you press On / Off key, indicator lights illuminate on the display for ON 3.
Page 29
Super Gloss Function Half Load function (Depends on model) (Depends on model) It provides superior drying performance. It is used to operate the machine without loading it completely. Auto Door Opening 1. Load your dishes in the machine as (Depends on the Model) you like.
Changing the settings while Time Changing Warning Sound Volume Delay function is active 1. After switching on your machine, While the Time Delay function is activated, press Time Delay and P / P+ keys you cannot make changes in the washing simultaneously.
Adjusting the amount of rinse The machine will remain silent in pause mode for some time in order to remove the water from the machine 1. After turning on the machine, and on the dishes completely and to press Time Delay and P+/P keys have the water softener cleaned, and simultaneously.
ProCare Leave your dishes in the machine for about 15 minutes to allow them cool (depends on model) down after they are washed. Your This programme is recommended to be dishes will dry in a shorter time if you operated on each 1-2 months for machine leave the door of your machine ajar cleaning and necessary hygiene.
Maintenance and Cleaning the filters cleaning Clean the filters at least once a week in order for the machine operates efficiently. Read “Safety Instructions” section first! Check if food residues are left on the filters. Unplug the product and turn off the If there are food residues on filters, take tap before attempting any cleaning them out and clean well under running...
Cleaning the hose filter Damages on the machine that may be caused by impurities coming from the urban supply water or your own water installation (such as sand, dirt, rust, etc.) can be prevented by means of the filter attached to the water inlet hose. Check the filter and the hose regularly and clean them if necessary.
Cleaning the impellers Clean the impellers at least once a week in order for the machine operates efficiently. Lower impeller Do not try to rotate the impeller by Check if the holes on the lower impeller (1) holding its ends. Trying to rotate the are clogged.
Troubleshooting Machine does not start. • Power cable is unplugged. >>> Check if the power cable is plugged in. • Fuse is blown. >>> Check the fuses in your house. • Water is cut. >>> Make sure that the water inlet tap is open. •...
Page 37
• Rinse aid is not sufficient. >>> Check the rinse aid indicator and add rinse aid if necessary. Increase the rinse aid setting if there is enough amount of rinse aid in the machine. • Machine is unloaded right after the programme is over. >>> Do not unload your machine right after washing process is completed.
Page 38
There is a different odour in the machine A new machine has a peculiar odour. It will fade out after a couple of washes. • Filters are clogged. >>> Check if the filter system is clean. Clean the filter system regularly as illustrated in section “Cleaning and Care”.
Page 39
• Opening of the detergent dispenser lid is prevented during washing. >>> Place the dishes in a way that will not prevent the detergent dispenser lid from opening and the water going into the machine from impellers. • Detergent is stored under unsuitable conditions. >>> If you are using powder detergent, do not store the detergent package in humid places.
Page 40
Foam forms in the machine. • Dishes are washed with hand-wash detergent by hand but not rinsed before placing them into the machine. >>> Hand-wash detergents do not contain antifoam. There is no need to hand-wash the dishes before placing them into the machine. Removing the coarse soil on the dishes under tap water, with a tissue paper or fork will be sufficient.
Guarantee Details • Cabinet or appearance parts, including but not limited to control knobs, flaps and handles. Your new Blomberg product is guaranteed • Accessories and/or consumable items against faulty materials, defective including but not limited to ice trays, components or manufacturing defects.
Page 42
Optional extras, where available (i.e. extendable feet) are supplied on a chargeable basis only. Does Blomberg offer replacements? This is a repair-only guarantee. On occasion the Manufacturer may at its sole discretion, replace your product with a new product instead of carrying out a repair. Where a replacement is offered, this would normally be an identical model, but when this is not possible, a model of similar specification will be provided.
Page 43
When will the repair take place? Our engineers work Monday to Friday 9.00am to 5.00pm. Appointments outside these hours may be possible at the sole discretion of the Manufacturer but cannot be guaranteed. Whilst our Engineers will endeavour to minimize inconvenience and to meet requests for specific timed appointments, this cannot be guaranteed.
Page 44
Should you experience any difficulty in obtaining service contact the Blomberg Customer Helpline on Tel: 0333 207 9870 or e-mail: customerservice@support.Blomberguk.com ………………………………………………..............