Servicing The Bedbar - Toro 03621 Original Instructions Manual

Figure 27
1. Bedknife (vertical)
2. Press the Alt Zero button on the angle indicator.
3. Place the angle-indicator mount on the edge of the
bedknife so that the edge of the magnet is mated with
the edge of the bedknife
Note: The digital display should be visible from the
same side during this step as it was in step 1.
Figure 28
1. Angle-indicator mount
2. Edge of the magnet mated
with the edge of the
bedknife
4. Place the angle indicator on the mount as shown in
Figure 28.
Note: This is the angle that your grinder produces,
and should be within 2 degrees of the recommended
top grind angle.
2. Angle indicator
(Figure 28).
3. Bedknife
4. Angle indicator

Servicing the Bedbar

Removing the Bedbar
1. Turn the bedbar-adjusting screws counterclockwise to
back the bedknife away from the reel
1. Bedbar-adjusting screw
2. Spring-tension nut
2. Back out the spring-tension nut until the washer is no
longer tensioned against the bedbar
3. On each side of the machine, loosen the locknut
securing the bedbar bolt
1. Bedbar bolt
4. Remove each bedbar bolt, allowing the bedbar to be
pulled downward and removed from the machine bolt
(Figure 30).
Note: Account for 2 nylon washers and 1 stamped
steel washer on each end of the bedbar
1. Bedbar bolt
2. Nut
16
(Figure
Figure 29
3. Bedbar
4. Washer
(Figure 29).
(Figure 30).
Figure 30
2. Locknut
(Figure
Figure 31
3. Steel washer
4. Nylon washer
29).
31).