Finish Drag Kit
Nail Drag for Sand Pro
Model No. 08718
Introduction
Read this information carefully to learn how to operate and
maintain your product properly and to avoid injury and
product damage. You are responsible for operating the
product properly and safely.
You may contact Toro directly at www.Toro.com for product
and accessory information, help finding a dealer, or to register
your product.
Whenever you need service, genuine Toro parts, or additional
information, contact an Authorized Service Dealer or Toro
Customer Service and have the model number of your
product ready.
This manual identifies potential hazards and has safety
messages identified by the safety alert symbol (Figure 1),
which signals a hazard that may cause serious injury or death
if you do not follow the recommended precautions.
Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
Chain
Chain sleeve
Bolt (3/8 x 1-1/4 inch)
Washer
Locknut
Bolt (3/8 x 1-1/4 inch)
Washer
Locknut
Carrier
Bolt (3/8 x 3/4 inch)
Locknut
© 2013—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
2040Z Traction Unit
This manual uses 2 words to highlight information.
Important calls attention to special mechanical information
and Note emphasizes general information worthy of special
attention.
Qty.
2
2
4
Install the chains.
8
4
4
8
Install the drag mat.
4
2
4
Install the carriers.
4
Register at www.Toro.com.
Figure 1
1. Safety alert symbol
WARNING
CALIFORNIA
Proposition 65 Warning
This product contains a chemical or chemicals
known to the State of California to cause cancer,
birth defects, or reproductive harm.
Original Instructions (EN)
All Rights Reserved *3378-567* A
Printed in the USA
Form No. 3378-567 Rev A
Operator's Manual
Use