Issue 3.0
SV9100 System Hardware Manual
Figure 9-113 Separate Tilt Leg from Leg Support
Tilt Leg
4.
Push the two stopper tabs through the slots to separate the tilt leg
from the leg support.
5.
Lay the tilt leg and the leg support flat to expose APR-L UNIT
compartment.
6.
Carefully pry loose the knockout covering the bottom option interface
(refer to
Figure 9-114 Bottom Option Interface
Figure 9-114 Bottom Option Interface Knockout
Knockout
7.
Using the exposed Bottom Option Interface as a guide, install the
APR-L UNIT in the bottom of the DTL multiline terminal. Push down
until left and right tabs are seated (Refer to
UNIT on page
9-132).
Stoppers
Knockout).
Bottom Option
Interface
Figure 9-115 Install APR-L
9-131