Operating; Operating Page Displays - ABB COMMANDER 1911 Operating Manual

5.2 Operating Page Displays

100. 3
110. 5
Heat/Cool
100. 3
Controllers
OP 50. 0
Motorized
Valve
Controllers
100. 3
r50. 0
100. 3
dEG F
Motorized Valve (position-proportioning and boundless)
100. 3
open
W 50. 0
O
W
stopped
C
close
Heat/Cool
100. 3
OP 50. 0
P.I.D. Output (%)
To adjust the output value
manually:
control mode using the
switch ('MAN'
illuminated) and then use the
and
the value required (between 0
and 100%).
Process Variable
Control Set Point
The set point in use is displayed (Local, Remote, Dual or Cascade). If the Local or
Dual set point is displayed it can be adjusted using the
providing adjustment is enabled in the
CONFIGURATION LEVEL
Process Variable
Control Output Value (%)
To adjust the output value manually: select Manual control mode using the
switch ('MAN' l.e.d. is illuminated) and then use the
the required value (between 0 and 100%).
Process Variable
Manual Reset
Use the
set point (between 0 and 100%). Manual reset only appears if enabled in the
Up Operating Page, CONTROL CONFIGURATION LEVEL
in the
Time
Continued on next page.
Process Variable
Valve Status and Valve Position (%)
W
O
C
The valve position is displayed as a percentage of its full travel position (not
displayed on boundless controllers). To adjust the valve position manually: select
Manual control mode using the
use the
the valve and
is stopped.
select Manual
l.e.d. is
switches to set
– refer to the
and switches to set a value which eliminates any offset from the
is 'OFF'.
OPERATOR LEVEL
– valve stopped
– valve opening
– valve closing
and switches to set valve position required (
switch closes the valve). With neither switch pressed the valve
100. 3
Oh 0. 0
Heat Output (%)
This frame is not displayed if
the P.I.D. output is below the
. The output
Crossover Value
can be adjusted using the
and switches when in the
Manual control mode.
5 CONTROL OPERATION...
and
Set Up Operating Page
.
Programming Guide
and
and the
switch ('MAN' l.e.d. is illuminated) and then
100. 3
Oc 0. 0
Cool Output (%)
This frame is not displayed if the
P.I.D. output
Crossover Value
be adjusted using the
switches when in the
Manual control mode.
switches,
,
CONTROL
switches to set
Set
Integral Action
switch opens
is above the
. The output can
and
13