Adding Rear Ballast And Weight Kit; Installing Ce Decals; Reducing The Tire Pressure; Burnishing The Brakes - Toro Greensmaster 04358 Operator's Manual

1. Alignment strip
2. Approximately 12.7 cm (5
inches)
6
Adding Rear Ballast and
Weight Kit
Parts needed for this procedure:
Rear Weight Kit (Part No. 100-6441)—purchase
1
separately
19.5 kg (43 lb) of calcium chloride (purchase
1
separately)
Rear Weight Kit (Part No. 99-1645)—purchase
1
separately if you have a 3-Wheel Drive Kit installed
Procedure
This machine complies with the ANSI B71.4-2017 and
EN ISO 5395:2013 Standards when you equip it with
the Rear Weight Kit (Part No. 100-6441) and add 19.5
kg (43 lb) of calcium chloride ballast to the rear wheel.
If you install a 3-Wheel Drive Kit, use the Rear Weight
Kit (Part No. 99-1645) instead of Part No. 100-6441.
Important:
If a puncture occurs in a tire with
calcium chloride, remove the machine from the
turf area as quickly as possible. To prevent
possible damage to the turf, immediately soak the
affected area with water.
Figure 11
3. Cut grass on right
4. Keep focal spot 1.8 to 3
m (6 to 10 ft) ahead of the
machine.
7

Installing CE Decals

EU Only
Parts needed for this procedure:
1 Warning decal (Part No. 133-2339)
1 Production year decal
Procedure
g005115
If this machine will be used in the EU, affix the warning
decal (Part No. 133-2339) over the warning decal
(Part No. 133-2338). Apply the production year decal
next to the regulatory decal.
8

Reducing the Tire Pressure

No Parts Required
Procedure
The tires are over-inflated at the factory for shipping
purposes. Reduce the pressure to the proper levels
before starting the machine. Refer to
Tire Pressure (page
9

Burnishing the Brakes

No Parts Required
Procedure
Firmly apply the brakes and drive the machine at
mowing speed until the brakes are hot, as indicated
by their smell. You may need to adjust the brakes
after the break-in period; refer to
(page 36).
14
Checking the
34).
Adjusting the Brakes