Table of Contents
Advertisement
MOUNTING AND COMRECTIHG TIlE HARD DISK DRIVE
Procedure:
Mounting and Connecting the Hard Disk Drive
/
1.
Remove the pre-folded 20-conductor ribbon cable from the
shipping kit.
If the folds on the ribbon cable are not crisp
and flat, run your finger over the folds several times.
2.
Position the cable connector over the 20-pin header at the
top of the controller board, and press it into place.
red strip
3.
Position the pre-folded 34-conductor ribbon cable over the
34-pin header at the top of the controller board and press it
into place.
'V""":?f--~--red strip
"'I.~~~--34-pin
header
- - - - )
18
HORIZON Hard Disk Installation Guide
Advertisement
Table of Contents
