Table 1-4 Vme System Controller - Switch (S10); Table 1-5 Battery Enable - Switch (S11); Table 1-6 Password Clear/Bios Boot Mode - Switch (S12) - GE V7768 Hardware Reference Manual

Table 1-4 VME System Controller - Switch (S10)

Position
1-4
1-4
2-3
2-3

Table 1-5 Battery Enable - Switch (S11)

Position
1-4
1-4
2-3
2-3
CMOS Password

Table 1-6 Password Clear/BIOS Boot Mode - Switch (S12)

Position
1-4
1-4
2-3
2-3
To clear the CMOS password:
When power is reapplied to the unit, the CMOS password will be cleared, and the
CMOS will be set to its defaults.
State
On
Off
On
Off
State
On
Off
On
Off
NOTE
The BIOS has the capability of password protecting casual access to
the unit's CMOS setup screens. The CMOS Clear jumper allows the
user to clear the password in the case of a forgotten password.
State
Off
On
On
Off
NOTE
The default settings in the tables are in bold.
1. Turn off power to the unit.
2. Move switch S12 position 1 to On.
3. Wait approximately 5 seconds.
4. Move switch S12 position 1 to Off.
5. Power up the unit.
Function
Force VME controller based on 2-3 state
Enable auto system controller
Force system controller (any slot)
Force non-system controller (any slot)
Function
Enable Battery
Disable Battery
Factory Use Only
Factory Use Only
Function
Normal
Clear CMOS/Password
Boot with Post Errors
Boot Halt on Post Errors
Installation and Setup 23
.